上海涌明自動化設備有限公司

加工中心用刀具檢測測頭
產品型號：TS27R
產品名稱：TS27R接觸式對刀和刀具破損檢測  
在機床上精確測量刀具長度和直徑無需機外對刀，可對旋轉刀具進行長度或直徑測量而不造成刀具或測針磨損，序中刀具破損檢測可識別破損的刀具，避免工件報廢，通過檢測長度和直徑來識別刀具，發現刀具的錯裝，雷尼紹可靠的測頭機構可在數百萬次觸發中保持承諾的精度，測針有弱保護結構，可防止在碰撞情況下對測頭的損害，有交換工作臺的機床可選用ＯＴＳ光學傳輸式測頭。
產品描述：
TS27R接觸式對刀和刀具破損檢測
●加工中心用標準對刀測頭
●超小型工作臺安裝
●精確的刀具長度和直徑測量
●可檢測旋轉刀具而不會造成刀具或測針磨損
●測針有弱保護，可防止發生碰撞時損壞測頭
About TS27R
TS27R is mounted on the machine table. It enables the user to set tool length and diameter of rotating tools， and to carry out broken tool detection.
As with all Renishaw hard-wired probe systems， TS27R requires theMI 8 interface to convert probe signals into an acceptable form for the CNC machine control.
TS27R features and benefits
?The standard tool setting probe for machining centres
?Compact table mounting
?Precise tool length and diameter measurement
?Rotating tools can be checked without wear to the tool or stylus
?Stylus is protected by a weak link， preventing probe damage in the event of a collision
TS27R specification
Specification
Sense directions  ±X， ±Y， +Z
Weight  650 g (23 oz)
Transmission type  Hard-wired
Uni-directional repeatability (max 2 sigma at stylus tip)   1.0 μm (0.00004 in)
Trigger force
Lowest force
Highest force  1.3 N (4.6 ozf)
2.4 N (8.5 ozf)
Stylus overtravel
XY plane
+Z direction  ±10°
5.5 mm (0.21 in)
Maximum recommended stylus length  Cranked stylus
27 x 33 mm (1.06 x 1.3 in)
Sealing  IP X8
Mounting  12 mm (0.5 in) T-bolt (not supplied).
Optional spiral pins to allow accurate re-mounting.
Compatible interface  MI 8 /MI 8-4

Software for TS27R
Renishawtool setting software allows you to set tool length and diameter offsets for single point and multiple point tools， perform in cycle broken tool detection and manual or automatic (programmed) positioning.